Our GPS units will pair with a wide variety of sensors such as heart rate, power, and speed/cadence. If you’re experiencing any problems, there could be a few possible reasons with easy solutions.
To start, make sure that your sensor and device are compatible and the sensor is supported by Lezyne. Our Mini and Macro GPS can pair only with Bluetooth devices, while Micro, Micro C, and Super GPS devices can pair to Bluetooth and ANT+ heart rate straps, power meters, and speed/cadence sensors.
Also, make sure to removed the cellophane from the battery. Our first batch of batteries came with clear cellophane around the edges, but later we changed it to yellow to make it more visible. This ends up being the solution to more than half of the calls we get about sensor problems.
Lezyne Heart Rate Flow Sensor
Our heart rate monitors will automatically display 65 bpm when they are paired to the device, but not yet detecting a heartbeat. You may only need to wet the terminals under the strap to get it to start displaying a reading. If the displayed heart rate appears to have frozen on another number, remove the sensor from the strap, wait five seconds, and reattach it. It's also a good idea to store the sensor separate from the strap to preserve battery life.
Lezyne Cadence Speed Flow Sensor
We've seen very few problems with our speed/cadence sensors. More often than not, if you're experiencing an issue, it's magnet placement. Please double check that the magnets are passing close enough to the sensor. We recommend 1-2 millimeters between the sensor arm and the spoke magnet; that's about a penny's width. The crank magnet needs to be within 5 millimeters.
If your bike is stored in a way that the magnet keeps waking the sensor in between rides, the battery could die prematurely.
Occasionally, the sensor arm can get turned or twisted too much and the wires running to it may have been damaged. You can check this by unscrewing the screw where the arm meets the body of the sensor and visually inspecting the wires.
Note: The crank magnet passing over the sensor is what wakes the sensor. An LED will show through the plastic on the sensor for 30 seconds, and it will be available for pairing for 2 minutes.
If the bike hasn’t been ridden for a while or you’ve recently updated the device, you might see that you're not getting a reading. Navigate to Sensors in the GPS menu and make sure it is currently paired. Often it only takes a quick re-pairing of the sensor to the GPS to solve the issue.